User's Manual

Dahua 5.8GHz Wireless AP/CPE User Manual
- 28 -
inform the station which sent request to send data.
Threshold Threshold: If the packet length surpasses the set value, it has to be divided into several data
segment to send, and the number can only be even.
Multicast Data: When this function is enabled, DH-PFM88X will allow the multicast packet to pass it.
Antenna Switch: Set the value as external antenna when the device is using external antenna.
Otherwise, it is built-in antenna.
Client Isolation: To enable this function can make the devices which connect to the same access point,
WDS AP and WDS Repeater not be intercommunicated. It won’t cause any influence to communication
even if the client IP is repeated.
Max Client Limit: Limit the quantity of client which connect to access point, WDS AP and WDS
Repeater and WDS client by setting it.
Enable Auto-Negotiation: When it is enabled, the LAN port will auto adjust its speed to max public level
according to the connection speed and duplex mode of the device on the other end.
Enable Full Duplex: If the LAN port of DH-PFM88X allows the data transmission in two directions at the
same time.
LAN Port Speed: For the LAN port speed of DH-PFM88X, there are only two kinds which are 10Mbps
and 100Mbps.
Signal Intensity LED Setting: The setting of LED1, LED2 and LED3 here is the signal intensity value
which is needed to light three LED lights. The signal intensity value of LED3 is the biggest
(LED3>LED2>LED1), default settings are LED1:-86dB, LED2:-71dB and LED3:-56dB respectively. The
LED1 will be on if the signal intensity is higher than LED1 but lower than LED2; both the LED1 and LED2
will be on when signal intensity is higher than LED2 but lower than LED3; All of the LED1, LED2 and
LED3 will be on when the signal intensity is higher than LED3.