User's Manual

Dahua 5.8GHz Wireless AP/CPE User Manual
- 23 -
Output Power: Users can adjust the output power of device transmitting wireless signal according to the
distance between devices. The transmitted signal distance and intensity will improve when output power
goes up.
Channel Width: It means max data transmission rate of the channel.
Max TX Rate: Limit the device max send/receive rate by setting it and keep the stability of device
performance by dong so.
Root Access Point MAC Address: Client, WDS Repeater or WDS client can limit the object that the
device is to connect by setting it.
Wireless Security Setting: Make encryption to wireless connection, users can select corresponding
encryption way according to their own demand for safety. The devices which are to be interconnected
need to be set the same wireless encryption, otherwise, they won’t be interconnected.
WEP: Wired equivalent encryption technology, a data encryption technology.
WPA: A kind of specification based on standard to enhance the interoperable safety, which has greatly
increased the control level of data protection and access in the existing and future WLAN system. It is
designed into the form of software upgrading and run on the existing hardware, Wi-Fi Protected Access
is from and will be compatible with the future IEEE 802.11i standard. After it is installed correctly, it will
provide users of wireless network with high-level protection, which will always make their data protected
and it is only open to those authorized network users. WPA made up all the defects of WEP.
7. Network Setting
7.1 Route Mode
DH-PFM88X is used as a router when it is under route mode; it has WAN port and LAN port. At this
moment, the LAN2 of DH-PFM88X is equivalent to the LAN port of router while the LAN port on POE