User's Manual

DH-PFM880 User Manual DaHua All Right Reserved
Page 40
y Configure WDS AP and WDS Repeater frequency to be the same, for
example: 5825MHz
y Configure the encryption method and password to be the same.
3. To verify if the network is correctly setup, please use the computer connected to
one of the three devices to ping the IP of any of the other two devices. If the ping
is successfully, the network connection works correctly.
13.3 Router Mode
In the Router mode, the DH-PFM880 works as a router and the network
connection is shown in Figure 32. The PoE port of the PoE adaptor is connected to
the DH-PFM880 device’s PoE port, and the LAN port of the PoE adaptor is
connected to the internet. Meanwhile, the LAN port of DH-PFM880 device is
connected to one computer, and then user can configure the device.
Figure 33 Route mode
After the above connection is done, configure the DH-PFM880 device using the
web based configuration menu.
1. In wireless page, set the device to route mode, disable the firewall. If the
internet provided by the ISP (DH-PFM880 connected to) has a DHCP server,
user can set DH-PFM880’s WAN mode to DHCP (Dynamic IP) so that it can
obtain the IP address automatically.
If the internet provided by the ISP(DH-PFM880 connected to) doesn’t have a
DHCP server, user need to manually configure all the parameters given by the
ISP, such as the WAN IP, WAN Netmask, LAN IP, LAN Netmask, Default
gateway, Primary DNS, Secondary DNS.