User's Manual
Table Of Contents
DH-PFM880 User Manual DaHua All Right Reserved
Page 39
1. Configure the two devices to bridge mode, disable the firewall, and set
different LAN IP for the two devices, the LAN IP should be on the same
segment.
2. In wireless menu, configure one device to AP mode and the other one to
station mode, set the same SSID, the same channel bandwidth (20MHz for
default), and set the same encryption and password for both of the devices.
3. After the above setting is done, wait for a while. Using one computer to ping
the other one. If the devices are configured correct, they will be associated and
the ping will get the reply.
13.2 WDS AP, WDS Station, WDS Repeater Network
Figure 32 WDS Network
If there is a block, such as a building is in between the point-to-point connection,
one TuroBridge5F device can be put between the PTP connection as a relay, which
is “WDS AP, WDS Station, WDS Repeater” network, shown in the above Figure33.
Three DH-PFM880 devices need to be configured as shown in Figure 33:
1. Configure the 3 devices to be bridge mode.
2. In the wireless menu, make the following configurations:
y Configure the 3 devices to WDS AP/WDS Repeater/WDS Station
separately
y Configure the 3 devices’ SSID to be the same