User's Manual

DH-PFM880 User Manual DaHua All Right Reserved
Page 37
client
Server: when it is a server, it waits client to connect.
Client: when it is a client, it sends connect request to server.
IPERF dual: client sends and receive signal at same time.
IPERF Server: Server IP address.
IPERF Thread: the number of iperf thread. If using more thread, the throughput is
high.
IPERF Time: how long the iperf run.
IPERF Interval: the time between two results show.
NoteIf users want to modify the parameters of Ping Watchdog, please
disable it first and then apply. When the web page shows that Ping
Watchdog is really disabled, users can now re-enable it with modified
parameters.
11 AC NMS
The AC NMS page is shown in Figure 31.If you want the device to join the AC
management you need AC management at first and then go to the AC NMS page
to enable the AC control.
WTP name: indicates the name of the device to show on the AC management.
WTP location: indicates the location information of the device to show on the AC
management.
AC IP: AC IP is the IP address of the AC management witch this device should be
joining in. It can be added up to eight.
When the AC control is enabled and the IP address is matched, the device can
be on-line in AC management, a client device must be associated to an access
point device which is on-line on the AC, and then it can be on-line on the AC
management.
When AC control is enabled, users can not configure the device through the
device pages except the AC NMS.