User's Manual

User’s Manual
22
7 Web Configuration
Connect the Radar to the camera through RS-485, and then you can configure the Radar to trigger
capture and measure speed.
 Refer to the user's manual of the camera for detailed configuration.
 Web configurations introduced in this section are mainly for ANPR events, and you can take
them as reference for other events.
 Make sure you have set the Intelligent Scheme to ANPR.
Connecting the Camera 7.1
The Radar can connect to the camera through RS-485 to monitor multiple lanes, and you can
configure the corresponding parameters on the camera web interface.
Log in to the camera web client. Step 1
Select Setting > Peripheral > Serial Port Settings. Step 2
Serial port settings Figure 7-1
Set Type to RS-485 and select Radar for the corresponding serial port to enable multi-lane Step 3
radar detection.
Radar configuration Figure 7-2
Select the protocol as shown in the above figure and configure other parameters as needed. Step 4
Click Confirm. Step 5