Quick Start Guide

7
6 Installation
●
Risk of electrical shock.
◇
Be sure to disconnect the power at the fuse or circuit breaker before installation.
◇
Verify that the supply voltage is correct. Connect the fixture to a 100-240 VAC 50/60 Hz power
source.
◇
Properly ground fixture.
◇
Always follow code standards when installing wired connection.
◇
We strongly suggest that you hire a licensed electrician to install the camera.
●
Risk of fire.
Do not install the camera near combustible or flammable surfaces.
●
Do not connect this light fixture to a dimmer switch or timer.
●
Make sure the mounting surface is strong enough to hold at least three times the weight of th
e
camera.
6.1 Installation Methods
Figure 6-1 Installation methods