Installation Instructions
About the Guide
With Imou AppOperating
Installing
Camera
Step 2
Scan the following QR code or search “Imou” in Google Play or App
Store to download and install Imou App.
Step 5
Step 4
Connect your smart phone to your Wi-Fi network, and make sure your
smartphone is connected to Wi-Fi network with 2.4 GHz band, and then
do the following operations to finish adding camera.
Run Imou App, and then register an account for first use.
Step 3
Wait for booting to be finished, and then the camera indicator flashes
with green light.
Note
If the Wi-Fi network changed or the indicator status goes wrong,
reset the camera, and then do step 5 to add it again.
If you have more than one camera, do step 5 to add them one
by one.
Disclaimer
Turn the adjustment knobs to loosen the lights, and then adjust
the light angles to give space to the mounting screw.
Hook one end of the hook into the hole on the mounting plate,
and the other end to the edge of the camera, so you can free
your both hands for the installing.
Connect the power wires.
-The black wire from the camera is neutral wire, connect this wire to
the reserved neutral wire.
-The white wire from the camera is hot wire, connect this wire to the
reserved hot wire.
Fix those two joints with wire nuts .
Step 7
Adjust the light and lens angle, and keep the PIR detetor parallel
to the ground to ensure optimal detection.
Step 1
Power on the camera.
Step 2
Install the mounting plate:
- Without junction box
Stick the mounting plate to the
junction box.
Install the mounting plate to the
middle of the opening with the
expansion bolts and self-tapping
screws.
- With junction box
The copper wire from the camera is ground wire. Connect the
ground wires together. use one of the supplied wire nuts if
necessary.
Step 5
Put away all the wires, attach the camera to the
mounting plate, and fix the camera with mounting
screws.
Step 8
Step 6
Step 4
Step 3
Step 1
With
power off at the breaker, remove the existing floodlight
from the junction box it is attached to and disconnect the wires.
Inspect the junction box to make sure water cannot get into it.
Note
If there is a mounting plate attached to your junction box,
remove that as well.
If you do not have an existing junction box, you will need to hire
a licnsed electrician to install one. Also be sure to comply with
your local codes.
Note
If you have installed the App, update it to the latest version.
This guide is for informational purpose only. Working with
electricity can be dangerous unless proper safety precautions
are taken. If you are not comfortable or are inexperienced with
the processes and tools described in this manual, we
recommend that you hire a licensed electrician.
All the design and software here are subject to change without
prior written notice.
All trademarks and registered trademarks mentioned are the
properties of their respective owners.
Please visit our website or contact your local service engineer for
more information.
If there is any uncertainty or controversy, please refer to our final
explanation.
-
-
-
-
Be sure to disconnect the power at the fuse or circuit breaker
before installation.
Always follow code standards when installing wired
connection.
Verify that the supply voltage is correct. Connect fixture to a
100 ~240VAC 50/60 Hz power source.
Properly ground fixture.
We strongly suggest you hire a licensed electrician to install
the camera.
Risk of fire.
Do not connect near combustible or flammable surfaces.
Note
Do not connect this light fixture to a dimmer switch or timer.
Make sure the mounting surface is strong enough to hold at
least
-
-
-
-
-
-
-
-
Risk of electrical shock.
WARNNING