Quick Start Guide

Introduction
Note:
Press and hold the reset button for 10 s to reset the camera.
Camera
The pattern of the LED indicator is included in the following table.
LED Indicator Status
Green light flashing
Green light on
Red light flashing
Green and red light
flashing alternately
Powered off/LED turned off
Rebooting after reset
Booting
Device malfunction
Waiting for network
Operating properly
Network connection failed
Off
Red light on
Firmware updating
QSG ×1Camera ×1 Positioning Map ×1
Power Adapter ×1 Screw Package×1
Version 1.0.0
Quick Start Guide
Built-in Mic
Indicator Light
Ethernet Port
Reset Button
Power Port
Built-in Speaker
PIR Detector
IR LED
Micro SD Card Slot
Digital Input/Output
Device Status
With Imou AppOperating
Step 1
Step 3
Connect the camera to power source with the power adapter.
Scan the following QR code or search “Imou” in Google Play or App
Store to download and install Imou App.
Run Imou App, and then register an account for the first use.
Step 2
Note: If you have installed the App, update it to the latest version.
Mounting Surface
Step 5
Step 4
Do the following operations to finish adding camera.
Wait for booting to be finished, and then the camera indicator flashes
with green light.
Note:
If the Wi-Fi network has changed or the indicator status goes
wrong, reset the camera, and then do step 5 to add it again.
If you have more than one camera, do step 5 to add them one
by one.
Select Wi-Fi
Wi-Fi XXXXXX1
Wi-Fi XXXXXX2
Wi-Fi XXXXXX3
...
Wi-Fi Password