User's Manual

4 Device Installation
Note
The following figure is for reference only, please refer to the actual device for more details.
Make sure the installation surface can at least support 3x weight of the camera and bracket. .
Figure 4-1
The device can adopt two
types of installation modes
which are wall mount and
pendant, the exact
installation steps are
shown as follows:
Step 1
Dig holes on the proper
installation surface
according to the hole sites
on the quick installation
board.
Step 2
Knock the expansion bolts
into the holes.
Step 3
Use self-tapping screws to
fix the quick installation
board well.
Step 4
Connect to device power.
Step 5
Adjust the monitoring angle and stick the device on the quick installation board.