C Series Home Camera Quick Start Guide V 1.0.
1 Packing List Device × 1 USB ×1 Power Adapter ×1 QSG ×1 Quick Installation Board ×1 Screw Package ×1
2 Product Appearance Figure 2-1 Please to Table 2-1 SN more 1 details 2 about each 3 component.
3 Operate by EasyViewer Step 1 Power on the camera. Step 2 Connect iphone to a WiFi signal. Step 3 Open EasyViewer (downloaded from APP Store), choose Device Manager. Figure 3-1 Step 4 Please select “P2P” when the network “WiFi configuration” for wireless example of wireless connection. cable is connected, select connection.
Figure 3-2 Step 5 Input a device name and scan the QR Figure 3-3 Step 6 Input the WiFi password, then “next”. code on camera, then “next”.
Figure 3-5 Step 7 Connection succeeds. Figure 3-6 Figure 3-8 Note: Please try again or check the WiFi The WiFi configuration will be closed if Protected Setup) function, please reset configure WiFi via EasyViewer. Figure 3-7 password if it failed.
4 Device Installation Note The following figure is for reference only, please refer to the actual device for more details. Make sure the installation surface can at least support 3x weight of the camera and bracket. . Figure 4-1 The device can adopt two types of installation modes which are wall mount and pendant, the exact installation steps are shown as follows: Step 1 Dig holes on the proper installation surface according to the hole sites on the quick installation board.
Note: This quick start guide is for reference only. Slight difference may be found in user interface. All the designs and software here are subject to change without prior written notice. All trademarks and registered trademarks mentioned are the properties of their respective owners. If there is any uncertainty or controversy, please refer to the final explanation of us. Please visit our website or contact your local service engineer for more information.
