Quick Start Guide

Camera ×1

QSG ×1

Bracket ×1

Power Cable ×1

Positioning Map ×1

Screw Package ×1

Battery ×1

Introduction

Note:

Press and hold the SYNC button for 8 s to reset the camera.

Press the SYNC button to pair with the base station.

Power Port

SYNC Button

Built-in Speaker

The pattern of the LED indicator is included in the following table.

LED Indicator Status Device Status

Green light flashing

Green light quick flashing

Green light stay on for 10 s, then off

Red light stay on for 10 s, then off

Red light stay on for 1 s, then off

Sleeping mode

Run out of battery

Alarm is triggered

Instructed to wake

Reconnecting Wi-Fi

Waiting for pairing with the base station

Pairing succeeded

Pairing timeout

Reset completed

Off

CameraListPacking

BatteryInstalling

PIR Detector

Lens

LED Indicator

Built-in Mic

Photosensor

Green light on

Version 1.0.2

Quick Start Guide

PAGE 1
Packing List Camera Introduction Installing Battery Power Port Built-in Mic Lens SYNC Button PIR Detector Camera ×1 QSG ×1 Power Cable ×1 LED Indicator Photosensor Quick Start Guide Built-in Speaker Note: Press the SYNC button to pair with the base station. Press and hold the SYNC button for 8 s to reset the camera. The pattern of the LED indicator is included in the following table. Version 1.0.
PAGE 2
Installing Camera Pairing with the base station Safety Instructions Step 1 Step 3 - On the base station: Press the SYNC button, and then the indicator on the base station flashes with white light. The pairing starts, and the indicators flash as described below: The system indicator on the base station stays on with white light for 10 s, and then off. The indicator on the camera stays on with green light for 10 s, and then off. The pairing succeeded then.
PAGE 3
√
PAGE 4
This equipment should be installed and operated with a minimum distance 20cm between the radiator and your body.