Quick Start Guide

ManualsBrandsZhejiang Dahua Vision Technology ManualsCamera & PhotoCONSUMER CAMERA

About the Guide

- This quick start guide is for reference only. Minor difference might be

found in user interface.

- All the design and software here are subject to change without prior

written notice.

- All trademarks and registered trademarks mentioned are the

properties of their respective owners.

- Please visit our website or contact your local service engineer for

more information.

- If there is any uncertainty or controversy, please refer to our final

explanation.

Installing

Camera

Make sure the mounting surface is strong enough to hold at least

three times of the device weight.

Step1 Drill screw holes on the mounting surface as the positioning plate

shows, and then put in the expansion bolts.

Step2 Attach the mounting plate to the mounting surface with the

self-tapping screws.

Step3 Attach the camera to the mounting plate, then power it up, and

then, adjust the lens to the ideal angle.

Step 5

Step 4

Connect your smart phone to your Wi-Fi network, and make sure your

smartphone is connected to Wi-Fi network with 2.4 GHz band, and then

do the following operations to finish adding camera.

Wait for booting to be finished, and then the camera indicator flashes

with green light.

Note:

If the Wi-Fi network has changed or the indicator status goes

wrong, reset the camera, and then do step 5 to add it again.

If you have more than one camera, do step 5 to add them one

by one.

Adding

Alarm Sensor

Note:

The alarm sensor is not included by default; you need to purchase

it separately if necessary.

There are two ways to add alarm sensor.

Method 1

Step 1

Press camera reset/pair button for 2 s to enter pairing

mode, and then the green light flashes.

Press the pair button of alarm sensor and the indicator light

will flash quickly and continuously.

The green light of camera will stop flashing if pairing

succeeds; the red light will flash if pairing fails.

Step 2

Step 3

Method 2

Scan the QR code on the sensor with Imou App, and then follow the

app guide to operate.

Camera

Self-tapping Screw

Positioning Map

Mounting Surface

Expansion Bolt

Mounting Plate

Summary of content (2 pages)

PAGE 1
Adding Alarm Sensor Step 4 About the Guide - This quick start guide is for reference only. Minor difference might be found in user interface. - All the design and software here are subject to change without prior Wait for booting to be finished, and then the camera indicator flashes with green light. Step 5 Connect your smart phone to your Wi-Fi network, and make sure your smartphone is connected to Wi-Fi network with 2.4 GHz band, and then do the following operations to finish adding camera.
PAGE 2
Camera Introduction Operating With Imou App Step 1 Built-in Speaker Scan the following QR code or search “Imou” in Google Play or App Store to download and install Imou App. Ethernet Port Note: If you have installed the App, update it to the latest version. Micro SD Card Slot Camera ×1 Power Cable ×1 Power Adapter ×1 Power Port Note: Quick Start Guide Lens The pattern of the LED indicator is included in the following table. LED Indicator Status Version 1.0.