User's Manual

38
4 Web Operations
The terminal can be configured and operated on the web. Through the web you can set
parameters including network parameters, video parameters, and terminal parameters; and
you can also maintain and update the system.
Initialization 4.1
You need to set a password and an email address before logging in to the web for the first time.
Open IE web browser, and enter the IP address (the default address is 192.168.1.108) Step 1
of the terminal in the address bar, and then press Enter.
 Use browser newer than IE 8, otherwise you might not log in to the web.
 Make sure that the computer used to log in to the web is in the same LAN with the
device.
 7-inch model X terminals have dual NICs. The default IP address for ETH1 is
192.168.1.108, and for ETH2 is 192.168.2.108.
Initialization Figure 4-1
Enter the new password, confirm password, enter an email address, and then click Step 2
Next.
 The password must consist of 8 to 32 non-blank characters and contain at least
two types of characters among upper case, lower case, number, and special
character (excluding ' " ; : &). Set a password of high security level according to
the password strength prompt.
 For security, keep the password properly after initialization and change the
password regularly.