User's Manual

25
3.9.3 Wiegand Configuration
Select Wiegand Input or Wiegand Output accordingly.
Select Connection > Wiegand.
Wiegand Figure 3-14
 Select Wiegand Input when an external card swipe mechanism is connected to the
terminal.
 When Serial Input is selected to make the terminal be connected to the reader in the
turnstile, you need to select Door 1 or Door 2 as needed.
Door 1: If Door 1 is selected, then the reader and terminal control the same door 
opening direction. For example, both the reader and terminal control the entering
direction into a place or all control the exiting direction from a place.
Door 2: If Door 2 is selected, the reader and terminal control different door opening 
directions. For example, the terminal controls the entering direction into a place and
the reader controls the exiting direction from a place.
 Select Wiegand Output when the terminal works as a reader that can be connected to the
terminal.
Table 3-8 Wiegand output
Parameter
Description
Wiegand Output Type
The Wiegand Output Type determines the card number or the digit
of the number that can be recognized by the terminal.
Wiegand26, three bytes, six digits.

Wiegand34, four bytes, eight digits.

Wiegand66, eight bytes, sixteen digits.

Pulse Width
You can set pulse width and pulse interval.
Pulse Interval
Output Data Type
You can select the types of output data.
User ID: If User ID is selected, and then user ID will be output.

Card No.: If Card No. is selected, and then card number will be

output.