User's Manual

24
Table 3-7 Active register parameter
Parameter
Description
Server IP Address
IP address of the managing platform.
Port
Port number of the managing platform.
Device ID
Subordinate device number on the managing platform.
3.9.1.3 Wi-Fi
You can connect the terminal to the network through Wi-Fi if the terminal has Wi-Fi function.
3.9.2 Serial Port Settings
Select serial input or serial output according to the use of the external devices.
Select Connection > Serial Port.
Serial port Figure 3-13
 Select Serial Input when external devices that are with card reading and writing functions
are connected to the terminal. Serial Input is selected to enable access card information
to be sent to the terminal and the management platform.
 When Serial Input is selected to make the terminal be connected to the reader in the
turnstile, you need to select Door 1 or Door 2 as needed.
Door 1: If Door 1 is selected, then the reader and terminal control the same door 
opening direction. For example, both the reader and terminal control the entering
direction into a place or all control the exiting direction from a place.
Door 2: If Door 2 is selected, the reader and terminal control different door opening 
directions. For example, the terminal controls the entering direction into a place and
the reader controls the exiting direction from a place.
 For terminals with face recognition, card reading and writing functions, if you select Serial
Output, terminal will send lock/unlock information to the terminal. There are two types of
lock/unlock information:
User ID 
Card No. 
 Select OSDP Input when card reader of OSDP protocol is connected to the terminal. The
terminal can send card information to the management platform.