User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 System Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Login
- 3.3 Resetting the Password
- 3.4 Door Parameter
- 3.5 Alarm Linkage
- 3.6 Talkback Setting
- 3.7 Time Section
- 3.8 Data Capacity
- 3.9 Video Setting
- 3.10 Face Detection
- 3.11 Network Setting
- 3.12 Safety Management
- 3.13 User Management
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrade
- 3.17 Version Information
- 3.18 Online User
- 3.19 System Log
- 3.20 Fusion Calibration
- 3.21 Advanced
- 3.22 Exit
- 4 SmartPSS AC Configuration
- 5 FAQ
- Appendix 1 Notes of Face Recording/Comparison
- Appendix 2 Cybersecurity Recommendations
75
Click Export Data to download the results.
Fusion Calibration
Set up the coordinate relationship between the white light face image and face heat map. When
calibration mode is enabled, the access controller will use the coordinate relationship to
measure temperature on the face heat map.
Only certain models support this function.
Select Temp Monitoring Mode to Calibration Mode. See "3.10 Face Detection" for
details.
Select Fusion Calibrate.
Select a model from Calibration Mode according to the type of the access controller.
Set up coordinate relationship
Click Calibration Point1.
Click the image on the left, and then left to set up a relationship between the two
locations.
Click Calibration Confirmed.
Repeat step 2–4 for calibration point 2–4.
Click OK.
(Optional) Click Default to reset all configuration the default settings.