User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 System Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Login
- 3.3 Resetting the Password
- 3.4 Door Parameter
- 3.5 Alarm Linkage
- 3.6 Talkback Setting
- 3.7 Time Section
- 3.8 Data Capacity
- 3.9 Video Setting
- 3.10 Face Detection
- 3.11 Network Setting
- 3.12 Safety Management
- 3.13 User Management
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrade
- 3.17 Version Information
- 3.18 Online User
- 3.19 System Log
- 3.20 Fusion Calibration
- 3.21 Advanced
- 3.22 Exit
- 4 SmartPSS AC Configuration
- 5 FAQ
- Appendix 1 Notes of Face Recording/Comparison
- Appendix 2 Cybersecurity Recommendations
39
Table 3-1 Parameter description
Parameter
Description
Name
Enter a name for the door that this access controller controls.
State
Select NC for normally closed, or NO for normally open. If either is selected,
the defined opening method will not be effective.
Opening
Method
See Step 3 above.
Hold Time (Sec.)
Unlock duration. If expired, the door will be locked.
Normally Open
Time
The door will be always open or closed.
Normally Close
Time
Timeout (Sec.)
A timeout alarm will be triggered if the door stays unlock for longer than
this value.
Duress Alarm
See Table 2-4.
Door Sensor
Intrusion Alarm
Overtime Alarm
Anti-passback
Alarm
Click OK.
Alarm Linkage
3.5.1 Setting Alarm Linkage
Alarm input devices can be connected to the access controller, and you can modify the alarm
linkage parameter as needed.
Log in to the web interface.
Select Alarm Linkage > Alarm Linkage.
Alarm linkage
Click to modify the alarm linkage parameters.