User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 System Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Login
- 3.3 Resetting the Password
- 3.4 Door Parameter
- 3.5 Alarm Linkage
- 3.6 Talkback Setting
- 3.7 Time Section
- 3.8 Data Capacity
- 3.9 Video Setting
- 3.10 Face Detection
- 3.11 Network Setting
- 3.12 Safety Management
- 3.13 User Management
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrade
- 3.17 Version Information
- 3.18 Online User
- 3.19 System Log
- 3.20 Fusion Calibration
- 3.21 Advanced
- 3.22 Exit
- 4 SmartPSS AC Configuration
- 5 FAQ
- Appendix 1 Notes of Face Recording/Comparison
- Appendix 2 Cybersecurity Recommendations
29
Parameter
Description
Debug Mode
Enable this mode to display the temperature of the blackbody on the standby
interface. You can correct the temperature of the blackbody accordingly.
Only certain models support this function.
When this mode is enabled, the door cannot be opened by any method.
Temperature
Display
If enabled, temperature will be displayed in unlock results.
Clear Captured
Photos
Delete all captured photos.
Face Privacy
If enabled, the standby interface will be covered in mosaic.
2.13.2 Result Feedback
There are 4 result feedback modes: Success/Failure, Only Name, Photo&Name, and
Photos&Name.
You can select a result feedback mode as needed.
Photos&Name Mode
The captured face image, the image saved in the face database, user ID, user name and time are
all displayed during unlock.
Photos and name mode (1)