User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 System Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Login
- 3.3 Resetting the Password
- 3.4 Door Parameter
- 3.5 Alarm Linkage
- 3.6 Talkback Setting
- 3.7 Time Section
- 3.8 Data Capacity
- 3.9 Video Setting
- 3.10 Face Detection
- 3.11 Network Setting
- 3.12 Safety Management
- 3.13 User Management
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrade
- 3.17 Version Information
- 3.18 Online User
- 3.19 System Log
- 3.20 Fusion Calibration
- 3.21 Advanced
- 3.22 Exit
- 4 SmartPSS AC Configuration
- 5 FAQ
- Appendix 1 Notes of Face Recording/Comparison
- Appendix 2 Cybersecurity Recommendations
12
2.8.1.5 NC Period
If a period is added to the NC period, then the door is normally closed in that period. Users can
not unlock the door in this period.
2.8.1.6 Remote Verification Period
If you configured the remote verification period, then when unlock doors during the period you
configured, remote verification is required. To unlock the door in this period, a door unlock
instruction sent by the management platform is needed.
You need to enable Remote Verification Period.
means enabled.
means not enabled.
2.8.2 Unlock
There are two unlock modes: unlock mode and temperature monitoring mode. The unlock
modes described in this section are for reference only, and might vary with the model.
2.8.2.1 Unlock Mode
When the Unlock Mode is on, users can unlock through cards, faces, fingerprints, passwords, or
any one of all the unlocking methods.
Log in to the Main Menu interface.
Select Access > Unlock Mode > Unlock Mode.