User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 System Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Login
- 3.3 Resetting the Password
- 3.4 Door Parameter
- 3.5 Alarm Linkage
- 3.6 Talkback Setting
- 3.7 Time Section
- 3.8 Data Capacity
- 3.9 Video Setting
- 3.10 Face Detection
- 3.11 Network Setting
- 3.12 Safety Management
- 3.13 User Management
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrade
- 3.17 Version Information
- 3.18 Online User
- 3.19 System Log
- 3.20 Fusion Calibration
- 3.21 Advanced
- 3.22 Exit
- 4 SmartPSS AC Configuration
- 5 FAQ
- Appendix 1 Notes of Face Recording/Comparison
- Appendix 2 Cybersecurity Recommendations
9
New User Info
Configure parameters on the interface.
Table 2-3 New user parameter description
Parameter
Description
User ID
Enter user IDs. The IDs can be numbers, letters, and their combinations, and the
maximum length of the ID is 32 characters. Each ID is unique.
Name
Enter names with at most 32 characters (including numbers, symbols, and letters).
Face
Make sure that your face is centered on the picture capturing frame and the access
controller will take a picture of the new user’s face automatically.
Card
You can register five cards at most for each user. On the card registration interface,
enter your card number or swipe your card, and then the card information will be
read by the access controller.
You can enable the Duress Card function on the card registration interface. Alarms
will be triggered if a duress card is used to unlock the door.
Only certain models support card unlock.
PWD
The door unlocking password. The maximum length of the password is 8 digits.
If the access controller is without touch screen, you need to connect the access
controller to a peripheral card reader. There are buttons on the card reader.