User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 System Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Login
- 3.3 Resetting the Password
- 3.4 Door Parameter
- 3.5 Alarm Linkage
- 3.6 Talkback Setting
- 3.7 Time Section
- 3.8 Data Capacity
- 3.9 Video Setting
- 3.10 Face Detection
- 3.11 Network Setting
- 3.12 Safety Management
- 3.13 User Management
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrade
- 3.17 Version Information
- 3.18 Online User
- 3.19 System Log
- 3.20 Fusion Calibration
- 3.21 Advanced
- 3.22 Exit
- 4 SmartPSS AC Configuration
- 5 FAQ
- Appendix 1 Notes of Face Recording/Comparison
- Appendix 2 Cybersecurity Recommendations
4
Initialization
Administrator password and an email should be set the first time the access controller is turned
on or after reset; otherwise the access controller cannot be used.
Initialization
Administrator and password set on this interface are used to log in to the web
management platform.
The administrator password can be reset through the email address you entered if the
administrator forgets the password.
The password must consist of 8 to 32 non-blank characters and contain at least two types
of characters among upper case, lower case, number, and special character (excluding ' " ; :
&).
Standby Interface
You can unlock the door through faces, fingerprints, passwords and cards.
The unlock methods might vary with different models.
If there are no operations in 30 seconds, the access controller will go to the standby mode.
The standby interfaces shown in this section are for reference only, and might differ from
the actual ones.