User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 Local Operations
- 2.1 Basic Configuration Procedure
- 2.2 Common Icons
- 2.3 Standby Screen
- 2.4 Initialization
- 2.5 Logging In
- 2.6 Network Communication
- 2.7 User Management
- 2.8 Access Management
- 2.9 Attendance Management
- 2.10 System
- 2.11 USB Management
- 2.12 Configuring Features
- 2.13 Unlocking the Door
- 2.14 Viewing Unlock Logs
- 2.15 System Information
- 3 Web Operations
- 3.1 Initialization
- 3.2 Logging In
- 3.3 Resetting the Password
- 3.4 Configuring Door Parameter
- 3.5 Intercom Configuration
- 3.6 Configuring Time Sections
- 3.7 Data Capacity
- 3.8 Configuring Video and Image
- 3.9 Configuring Face Detection
- 3.10 Configuring Network
- 3.11 Safety Management
- 3.12 User Management
- 3.13 Configuring Voice Prompts
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrading System
- 3.17 Viewing Version Information
- 3.18 Viewing Logs
- 4 Smart PSS Lite Configuration
- Appendix 1 Important Points of Intercom Operation
- Appendix 2 Important Points of QR Code Scanning
- Appendix 3 Important Points of Fingerprint Registration Instructions
- Appendix 4 Important Points of Face Registration
- Appendix 5 Cybersecurity Recommendations
64
3.12 User Management
You can add or delete users, change users' passwords, and enter an email address for resetting the
password when you forget your password.
3.12.1 Adding Users
You can add new users and then they can log in to the webpage of the Access Controller.
Procedure
Step 1 On the home page, select
User Mgmt.
>
User Mgmt.
.
Step 2 Click
Add
, and enter the user information.
●
The username cannot be the same with existing account. The username consists of up
to 31 characters and only allows for numbers, letters, underscores, midlines, dots, or @.
●
The password must consist of 8 to 32 non-blank characters and contain at least two
types of the following characters: Upper case, lower case, numbers, and special
characters (excluding ' " ; : &).
Set a high-security password by following the password strength prompt.
Figure 3-41 Add user
Step 3 Click
OK
.
Only admin account can change password and admin account cannot be deleted.
3.12.2 Adding ONVIF Users
Open Network Video Interface Forum (ONVIF), a global and open industry forum that is established
for the development of a global open standard for the interface of physical IP-based security
products, which allows the compatibility from different manufactures. ONVIF users have their