User's Manual

32
Table 3-3 TCP/IP
Parameter
Description
IP Version
IPv4.
MAC Address
MAC address of the device.
Mode
Static: Set IP address, subnet mask, and gateway address manually.
DHCP
 After DHCP is enabled, IP address, subnet mask, and gateway
address cannot be configured.
 If DHCP is effective, IP address, subnet mask, and gateway
address will be displayed automatically.
 If you want to see the default IP when DHCP is effective, you need
to disable DHCP.
Link-local
address
Only available when IPv6 is selected in the IP version. Unique link-local
addresses will be assigned to network interface controller in each local area
network to enable communications. The link-local address cannot be
modified.
IP Address
Enter IP address, and then configure subnet mask and gateway address.
IP address and gateway address must be in the same network segment.
Subnet Mask
Default Gateway
Preferred/
Alternate DNS
Server
Set IP address of the preferred DNS server.
Click OK to complete the setting.
3.9.2 Port
Set the maximum connections clients that the device can be connected to and port numbers.
Log in to the web interface.
Select Network Setting > Port.
Configure port numbers. See the following table.
Except max connection, you need to restart the device to make the configuration
effective after modifying values.
Table 3-4 Port description
Parameter
Description
Max
Connection
You can set the maximum connections of clients that the device can be
connected to.
Platform clients like SmartPSS AC are not counted.
TCP Port
Default value is 37777.
HTTP Port
Default value is 80. If other value is used as port number, you need to add this
value behind the address when logging in through browsers.
HTTPS Port
Default value is 443.