User's Manual

13
On the main menu, select Comm > Serial Port, and then tap OK.
Serial port settings
 Select Serial Input when the device connects to a card reader. The card reader will send
the card number to the device or SmartPSS AC.
 Select Serial Output when the device works as a card reader. The device will the card
number to the controller, which will determine whether to unlock the door.
UserID: Outputs the ID of the user who swipes a card.
Card No.: Outputs the card number that is used.
 Select OSDP Input when the device connects to a card reader through OSDP protocol. The
card reader will send the card number to the device or SmartPSS AC.
2.9.5 Mode Settings
Set the device to work as a controller or card reader.
On the main menu, select Comm > Mode Setting.
Serial port settings
 Mode
Controller: The device works as an access standalone. You can use different
unlocking methods to unlock the door. You can also connect it to a card reader, and
then the card reader can send the information to the device or SmartPSS AC.
Card Reader: The device works as a card reader, and it can be connected to a
controller or another access standalone.