User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 Local Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Logging In
- 3.3 Resetting the Password
- 3.4 Data Capacity
- 3.5 Configuring Video and Image
- 3.6 Configuring Face Detection
- 3.7 Configuring Network
- 3.8 Safety Management
- 3.9 User Management
- 3.10 Maintenance
- 3.11 Configuration Management
- 3.12 Upgrading System
- 3.13 Viewing Version Information
- 3.14 Viewing Logs
- 4 Smart PSS Lite Configuration
- Appendix 1 Important Points of Face Registration
- Appendix 2 Cybersecurity Recommendations
38
Step 5 Configure parameters.
Table 3-9 Description of adding IP parameters
Parameter Description
Type
Select the address type from the
Type
list.
IP Version IPv4 by default.
All Ports
Select
All Ports
check box, and your settings will apply to all
ports.
Device Start Port
If you clear
All Ports
check box, set the device start port and
device end port.
Device End Port
Step 6 Click
Save
, and the
IP Authority
interface is displayed.
Step 7 Click
OK
.
●
Click to edit the allowlist or blocklist.
●
Click to delete the allowlist or blocklist
3.8.1.2 Prohibit PING
Step 1 Select
Prohibit PING
from the
Type
list.
Step 2 Select the
Enable
check box.
Figure 3-13 Prohibit PING
Step 3 Click
OK
.
3.8.1.3 Anti Half Connection
Step 1 Select the
Anti Half Connection
from the
Type
list.
Step 2 Select the
Enable
check box.
Step 3 Click
OK
.
3.8.2 Configuring System
Step 1 Log in to the web interface.
Step 2 Select
Safety Mgmt.
>
System Service
.
Step 3 Enable or disable the system services as needed.