User's Manual

User’s Manual
15
To arm the system without a passcode, you can enable the No Passcode Arming function
first, and then press and hold or .
●
To arm a single room, you can enter the relevant arming command.
◇
If the arming is successful, the arming and disarming indicator light will flash blue 3
times slowly, and then will remain solid, with one short beep.
◇
If the arming fails because of the potential faults, the arming and disarming indicator
light will flash green twice quickly, and then it will go back to the normal status, with
one long beep. And if you enter the same arming command again within 30 seconds, or
swipe the same card again within 10 seconds, you can force arm the room.
◇
If arming fails because of reasons such as using the wrong passcode or invalid card, or
allowing people with no permission to use the keypad, the backlit light will flash twice
quickly with one long beep.
By swiping the card, you can only use global away arming.
8.4 Disarming
●
If global disarming is successful, the arming and disarming indicator light will flash green 3
times slowly, and then turn off, with 2 short beeps.
After successfully disarming the system, if there are system faults, the fault indicator light
will flash yellow slowly.
●
If disarming for a single room is successful, the arming and disarming indicator light will
slowly flash green 3 times, and then it will go back to the normal status, with 2 short beeps.
●
If disarming fails because of reasons such as using the wrong passcode or invalid card, or
allowing people with no permission to use the keypad, the backlit light will flash twice
quickly with one long beep.