User's Manual

User’s Manual
14
8 Operations
8.1 Frequently Used Commands
Following are frequently used commands for the keypad.
Before using the keypad, make sure you have created accounts on the DMSS or COS app.
Table 8-1 Command
Function
Command
Global away arming Enter the password + + #.
Global home arming
Enter the password + + #.
No passcode arming Press and hold or .
Global disarming
Enter the password + + #.
Away arming for a single room Enter the password + * + Room No. + + #.
Home arming for a single room
Enter the password + * + Room No. + + #.
Disarming for a single room Enter the password + * + Room No. + + #.
Searching for the room status
Enter the password + * + Room No. + #.
Clear Press and hold #.
8.2 Waking Up the Keypad
Press and hold any key for more than 0.1 seconds to wake up the keypad. When you hear a
short beep, and see all the indicator lights are solid, then you can use it.
●
If you do not use the keypad for more than 4 seconds, the backlit LCD display will be dim,
and the status of the indicator light will remain the same.
●
If you do not use the keypad for more than 12 seconds, the keypad will beep twice, all the
indicator lights will turn off, and then the keypad will enter sleep mode.
●
To wake up the keypad when it is offline, the communication indicator will flash green
slowly, and other indicator lights, including arming and disarming, fault, and alarm
indicators, will turn off.
8.3 Arming
●
To arm all the rooms, you can enter the arming commands or swipe the card.