User's Manual

User’s Manual
10
Parameter Description
Transmit Power
Select from high, low, and automatic.
The higher transmission power levels are, the further
transmissions can travel, but power consumption increases.
If you select Low, the keypad will enter into reduced
sensitivity mode.
Card Reader Config
Enable card reader function and soft encryption function on
the keypad.
●
Card Reader: Enable by default. If enabled, the keypad
supports card recognition function. If disabled, the card
reader function will be turned off.
●
Soft Encryption: Enable by default. If enabled, card
information will be encrypted when issuing the card.
Backlight Brightness
Adjust backlit keypad brightness. You can select from Off,
Low and High.
When battery level is low, the backlight brightness will turn
to Low automatically.
Buzzer Volume
Configure volume level of the buzzer. Select from Off, Low,
and High.
Signal Strength Detection
Test the current signal strength.
Signal strength test is not supported when the keypad is in
the sleep mode. You can press any key to wake up the
keypad.
Cloud Update Update online.
Delete
Delete the keypad.
Go to the hub screen, select the keypad from the accessory
list, and then swipe left to delete it.