User's Manual

User’s Manual
15
Parameter Description
Delay Time
The system provides you with time to leave or enter the
protection zone without alarm.
●
Delay Time for Entering Arming Mode: When you
enter the zone, if you do not disarm the system before
the delay ends, an alarm will be triggered.
Make sure that the delay time for entering arming mode
is no longer than 45 seconds in order to comply with
EN50131-1.
●
Delay Time for Exiting Arming Mode: When you are in
the zone and arm the system, if you do not leave the
zone before the delay ends, an alarm will be triggered.
You can select from 0 s to 120 s.
The arming mode will be effective after the delay time.
Sensitivity
●
Sensitivity level during a shock alarm.
●
Select from low, medium and high.
Siren Linkage
When an alarm is triggered, the accessories will report the
alarm events to the hub and alert with siren.
Signal Strength Detection Test the current signal strength.
Detector Test
Tap Start Detection to test the status of the PIR–Camera.
RF-HD Test
Tap Start Detection to test the signal strength for
transmitting images between the PIR–Camera and the hub.
Transmit Power
Select from high, low, and automatic.
The higher transmission power levels are, the further
transmissions can travel, but power consumption increases.
If you select Low, the PIR–Camera will enter into reduced
sensitivity mode.
Cloud Update
Update online.
Delete
Delete the PIR–Camera.
Go to the hub screen, select the PIR–Camera from the
accessory list, and then swipe left to delete it.