User's Manual

User’s Manual
14
Parameter Description
Snapshot Config
Configure the number of snapshots that can be taken at a
time, the interval and the parameters of the image.
●
Tap Times to Take Snapshots, and then select times
from 1 to 10.
●
Tap Trigger Interval, and then you can select 10, 30, 60,
or 120 seconds.
●
Tap Image resolution and Quantity, and then for the
image resolution, you can select 1600 × 1200, 1280 ×
960, 640 × 480, or 320 × 240. For the image quantity,
you can select between 1 and 20.
For image resolution 1600 × 1200, you can only select
between 1 and 10 for the image quantity.
LED Indicator
LED Indicator is enabled by default. For details on indicator
behavior, see "3.1 Appearance".
If LED Indicator is disabled, the LED indicator will remain off
regardless of whether the PIR–Camera is functioning
normally or not.
Over-temperature Alarm
Enable the Over-temperature Alarm function, and then the
alarm will be triggered when the temperature of the area
where the PIR–Camera is installed is higher or lower than the
defined one.
24 H Protection Zone
Enable the 24 H Protection Zone function, and then the
accessory located in the 24 h protection zone is always
active whether the security system is configured in the
armed mode or not.
Home Mode
Enable the Home Mode, and then the selected accessories
under the hub will be armed.
Delay Mode under Home
Mode
Enable the Delay Mode under Home Mode, the selected
accessory under the hub will be armed and the alarm will not
be triggered until the end of customized delay time.
Only enable Home Mode first can Delay Mode under
Home Mode take effect.