User's Manual

User's Manual
7
6 Configuration
You can view and edit general information of the repeater.
6.1 Configuring the Repeater
On the
Hub
screen, select the repeater as needed from the accessory list, and then tap to
configure the parameters of the repeater.
Table 6-1 Repeater parameter description
Parameter Description
Device Configuration
●
View device name, type, SN and device model.
●
Edit device name, and then tap
Save
to save configurations.
Area Select the area to which the repeater is assigned.
Temporary Deactivate
Tap
Temporary Deactivate
to enable or disable the functions of the
repeater.
●
Tap
Enable
, and then all accessory messages will be forwarded
to the alarm hub.
Enable
is set by default.
●
Tap
Only Disable Tamper Alarm
, and then the system will only
ignore tamper alarm messages.
●
Tap
Disable
, and then no accessory messages will be forwarded
to the alarm hub through the repeater, and the system will
ignore fault messages coming from the repeater.
◇
If disabled, all the accessories that were manually set to
forward messages through the repeater will be offline. Those
selected to automatically send messages to the hub will
select another communication path.
◇
Even if you disable the functions of the repeater, the status of
the accessories will be displayed as normal.
LED Indicator
LED Indicator
is enabled by default. For details on indicator
behavior, see "3.1 Appearance".
If
LED Indicator
is disabled, the LED indicator will remain off
regardless of whether the repeater is functioning normally or not.