User's Guide
7
■ ■ No data in memory, press “ ” instrument displays “no”.
■ ■ When display clear interface, press “C” to exit clear state
How to set the filter parameters
■ Step 1: press key “
” to display: “F1”;
■ Step 2: press “
” or “ ”to increase or decrease the last digit;
■ Step 3: when it displays “F5”, press “
” to display the interface of filtering setup “FLt
2”, the last flickering digit is the current filtering value;
■ Step 4: at this time, press “
” or “ ”to increase or decrease the filtering value;
■ Step 5: after select the filtering, press “
” to confirm it and Press “ ”back to the
weighing mode.
Attention:
■ ■ Please set the parameter according to the using conditions. If it is not stable,
please increase the filtering value.
■ ■ The large the filtering value is, the low displaying speed the indicator has.
■ ■ TO weighing mode,the value from1-3; to, to force measurement the value from
0-3.
Battery and Charging
Charging Indicator
■ Two lower voltage indications:
1. When weighing,if indicator shows “DC LL”, means it on lower voltage indication.
It can be continued to use 15 minutes after low power,after 15 minutes transmitter
end shutdown automatically
2. When turning on, indicator shows “DC LL” immediately,it will not enter the
self-check mode, please charge ASAP or it will shut down within 3 seconds.
Charging Scale
■ Lower power alarm:
1. hen hand-held display is in process of normal weighing,first at left displays “L”,
Indicates transmitter batteries in low power, need to be recharged. It can be
continued to use 30 minutes after low power,after 30 minutes transmitter end
shutdown automatically.
2. After turning on power,if hand-held instrument displays above, shows batteries of
hoist scale end under-voltage,please recharge. After several seconds transmitter of
hoist scale shutdown automatically.