User's Manual

3-2.Then screw up the locking plate bracket to locking plate by 4pcs②M6*
10mm Flat Head Screw. Insert two square tubes to the hole of locking plate
bracket, then screw up them by 2pcs③plastic head screw( Let the stamped
lines on the square tubes close to the edge of locking plate bracket), hang
TV brackets (2pcs) on the square tubes and tighten them by③4pcs plastic
head screws( Keep the distance between the two brackets same asthe dist-
ance of the horizontal holes on TV back cover) (Diagram 2)
3-4. Put the pad between TV bracket and the holes on TV back
cover, and then fasten them by 2pcs⑦washer and 2pcs pan
head screw. (Diagram 4)
2pcs⑧
⑤M5*23mm
3-3.Screw up the 2pcs⑥tab to the upper holes of TV back cover by 2pcs
④sink head screw, then hang TV to the corresponding holes of TV bracket
by the two tabs.(Diagram 3)
2 PE O PL E L IF T T H E
AS S EM B LY UN I T.
B: Fix the TV
bracket at two end of
square tube, tighten
by 6pcs plastic head
screws.
A: Lock the square tube and main bracket
according to the stamping line of tube.
(Diagram 2)
(Diagram 3)
M6*18
Plastic head
crew
Stamping line of square tube
Tab
M6*10mm
M5*28mm
Locking plate
bracket
(Diagram 4)
M5*23mm
Pad
Washer
(Diagram 5)
Connecting with TV
Connecting with external interface
Power
supply outlet
(A)
(B)
AUDIO
VIDEO
TV
R L
POWER (100~220V)
3-5.
(A)
(B)
Only make sure your installation is correct, you can connect the power
supply, please connect interface on the back of TV mount with TV, and
connect interface with power supply and audio/ video/signal /data int-
erface. For your safe, please connect them strictly comply with the
instruction. (Diagram5)
4-1.Function
4. .User 's Guide
This product can be controlled
by remote control to adjust the
angle of TV to turn180° to left
or right .(Diagram6)
(Diagram 6)
Turn 180° to left or right
4-2.1.Key Function
4-2.Remote control(Diagram7)
1
8
0°
1
8
0°
Left :Press the key, the mount will turn left.
Right: Press the key, the mount will turn right.
L Return: Press the key, the mount will turn
left to the origin position.
R Return: Press the key, the mount will turn
right to the origin position.
Indicator: It shows the status of key open
or close.
Indicator
light
(Diagram 7)
Left
Right
L Return
R Return
L
e
f
t
R
ig
ht
L
Re
tu
rn
R Re
tu
r
n
(4) (3)