User's Manual

3-1.Put the base on the table, Fasten the locking plate on the base
by 6pcs①M5*6mm pan head screw.(Diagram 1)
assembly
assembly Cross
Warning:
Correct installation is extremely essential , and falls outside the
scope of responsibility of manufacturer . The user must pay atten
tion to the weight of TV and this product, and only solid table can
support the weight. Please comply with the installation instruction
of LCD/PDP to install them.
3. Installation Instruction
(Diagram 1)
Base assembly
Bottom
Indicater
Coding key
Locking plate
M5*6mm
2.Electric Specifications
2-1.Input Voltage/Current /Frequency, Output Current
A.
B.
Input Voltage/Current /Frequency: 100-240VAC/<0.65A/50~60Hz
Output Current:DC12V,2A
2-2.Motor
Item
Rated
Voltage
Current
(Not Load)
Current
(Rated Load)
Operating
Temperature
Motor
DC12V
≤0.3A ≤0.6A
-20℃~50℃
4-2.2 Operating Instruction
A. Insert one 23A 12V battery in the , the effective distance is
within 10 meters.
When user presses any function key (left, and right) of Remote control,the
TV bracket with TV will move to the corresponding direction, and will stop
when you loosen the key.
Remote control
B.
Changes or modifications not expressly approved by the party resp-
onsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against ha-
rmful interference in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful inte-
rference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined b turning the interference by one or more of the fo-
llowing measures:
--Reorient or relocate the receiving antenna.
--increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
4-2.3 Notice
Warning:
(2) (5)
A. Memory cleaning: pressing coding key about 10 seconds, the
memory will be cleaned after the indicator closed. (The memory is the
coding memory of the previous remote control)
B.Use new remote control: pressing any key of remote control and
the coding key 1-2 seconds at the same time, loosening remote control
firstly, then loosen the coding key, finally, you can operate the product
with new remote control. ( )indicator, coding key see diagram 1
If any remote control of our product was lost or damaged, you can
buy a new remote control with the same frequency which produced by
our company and do following operation: