User's Manual

3-1.For using in cabinet, make a mark on the rear of cabinet according
to the hole position of support bracket. Drill the hole on the mark,Ø
8.5mm. Fasten stand against cabinet by 2pcs① M8*25mm pan head
screw and 2pcs②M8 Nut. (see diagram 1)
3-2.For installing against the wall, ensure there are not any reinforced
steel bar or iron block in the wall and the wall is not soft, make a mark
on the wall according to the hole position of support bracket.
Drill the hole on the mark depth 50~60mm,Ø10mm by electric drill.
Take out 2pcs③Ø10*47mm Nylon plastic plug and insert them into the
holes,and fasten the④M6*50 mmHexagon flange wood screw through
the holes of support bracket into the plug by Spanner, ensure that the
post assembly can not be moved. (See diagram 2)
.
3-8.Using special remote control that attached to test this product.This
lift mount is composed of section, the max rising length is 860
mm, If the test result is ok, it means installation is finished.
three
3-7. After ensure that the above step is ok,please insert the power of
this product. ( diagram 7) see
2- 8.5mm Ø
8.5m m
M8*25mm
M8
Diagram 7
Diagram 1
2- mm
Ø10
60 m m
10 m m
M6*50mm
Ø m10*47 m
Diagram 2
Remote control
Diagram 8
Coding key
Indicator light
The max rising length is 860mm
It only uses special power to insert
the power supply outlet of this
product. Do not use other power.
860mm
Diagram 9
Indicator
light
RA
I
SE
L
O
W
ER
Horizontal
Position
Lower
elevating
stand
V
.P.
H.
P.
Vertical
Position
Raise
elevating
stand
4. Remote control(see diagram 9)
4-1.Key function
V.P. : one push to extend elevating stand
to the top.
H.P.: one push to back elevating stand
to the bottom.
Raise:hold on to raise elevating stand.
Lower: hold on to lower elevating stand.