User's Manual

2. Electric Specification
2.1 Input Voltage/Current/Frequency:
100-240V/<1.2A/50~60Hz
2.2 Output Current:DC24V,3A
2.3 Motor
1-3 Installation Tool(Not included) :
Item
Motor
Rated
Voltage
DC24V
Current
(NoLoad)
≤0.7A
Current
(Rated Load)
≤1.8A
Operating
Temperature
-20℃~50℃
Hammer
Cross screw
driver
PencilElectric drill
10MM
Spanner
14MM
Correct installation is extremly essential, and falls out-
side the scope of responsibility of manufacturer.The user
must pay attention to the weight of TV and this product,
and only solid wall can support the weight.
Please complywith the installation instruction of LCD/
PDP to install them.
Warning:
off the two screws on the
fastener,and keep the fas-
tener by yourself.Then
screw up the two screws
to the original place.
( diagram)
Firstly,you must screw
see right
fastener
3. Installation Instruction
5.Technical Parameters:
Item
Model
Product
Dimension
TV Size
Max
Installation
Min
Installation
Net WeightLoading
(mm) (mm)
(mm)
Extending
Length
(mm)
(kg)(kg)
(inch)
32
440*235*790
400*300 200*100
50 860
28.5±0.5
ZX-C33A
8.5MM
A: Memory cleaning: pressing coding key about 10 seconds, the
memory will be cleaned after the indicator closed. (The memory is the
coding memory of the previous remote control)
B: Use new remote control: pressing any key of remote control and
the coding key 1-2 seconds at the same time, loosening remote control
firstly, then loosen the coding key, finally, you can operate the product
with new remote control. ( 7) Coding key,Indicator,Please see dingram
4-2.Operating method
4-3.Notice
If any remote control of our product was lost or damaged, you can
buy a new remote control with the same frequency which produced by
our company and do following operation:
Aim the remote control at TV to operate. The effective distance
is within 10m.
B: This remote control matches one 23A12V battery. If the battery
ran out, please open the battery cover to exchangenew one.
C: When user press any function key of remote control, the TV
bracket with TV will move to the corresponding place ,and will stop
when you loosen the key.
A:
Warning:
Changes or modifications not expressly approved by the party resp-
onsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against ha-
rmful interference in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful inte-
rference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined b turning the interference by one or more of the fo-
llowing measures:
--Reorient or relocate the receiving antenna.
--increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Warning: