User's Manual

3-8.Using special remote control that attached to test this product.This
lift mount is composed of two section,the max rising length is 350mm,
It also can swivel right or left 15°,Tilt up 5°or tilt down 10°. If the test
result is ok, it means installation is finished. ( diagram 8)see
3-7.After ensure that the above step is ok, please insert the power of
this product. ( diagram 7) see
Remote control
Swivel right/left15°
Coding key
Indicator light
3-1.Fix the base plate(A)and post assembly(B)by 6pcs ① M5*25mm
pan head screw. ( diagram 1)
of
Cross see
Firstly, you must screw off the two screws on the fastener, and
keep the fastener by yourself.Then screw up the two screws to
the original place. ( diagram 1)see
3-2. there are not any reinforced steel bar or iron block in the wall
and the wall is not soft, then make a mark on the wall according to the
hole position of support bracket. Drill two holes on the mark 50~60mm
depth,Ø10mm by electric drill. Take out 2pcs② Ø m nylon
plastic plug and insert them into the holes, and fasten the ③M6 m
Hexagon wood screw through the holes of support bracket into
the plug by spanner, Be sure that the post assembly can not be moved.
( diagram 2)
Ensure
flange
see
10*47 m
*50 m
Diagram 1
2 PE O PL E L IF T T HE
AS S EM B LY UN IT.
Diagram 2
Ø10*47 mm
60mm
10mm
2- 10mm
Ø
M6*50mm
Diagram 7
Diagram 8
Down 10°
Up 5°
350mm
The max rising length is 400mm
B:Post assembly
A:Base plate
fastener
M5*25mm
It only uses special power to insert the
of this product.
Do not use other power.
power supply outlet
Warning:
4.Remote control(see diagram 9)
4-1.Key function
Left :Press the key the bracket will turn left.
Right:Press the key the bracket will turn right.
Up:Press the key the bracket will tilt up.
Down:Press the key the bracket will tilt down.
Raise:Press the key the post will lift.
Lower:Press the key the post will move down.
Indicator light
Lower
Raise
Left
Right
Tilt up
Return
Tilt down
Stop
DOWN
L
EF
T
U
P
R
A
I
SE
RETURN
LOWER
R
I
G
HT
S
T
OP
Diagram 9