User's Manual

5.Technical Parameters:
2. Electric Specification
2.1 Input Voltage/Current/Frequency:
100-240V/<1.2A/50~60Hz
2.2 Output Current:DC24V,3A
2.3 Motor
1-3 Installation Tool(Not included) :
Notice:
Check all the parts as shown on the mannual included.
If parts are missed or damaged, do not use it and please
return to your local distributor.
Correct installation is extremly essential, and falls out-
side the scope of responsibility of manufacturer.The user
must pay attention to the weight of TV and this product,
and only solid wall can support the weight.Please comply
with the installation instruction of LCD/PDP to install
them.
Warning:
Item
Motor
Rated
Voltage
DC24V
Current
(NoLoad)
≤0.7A
Current
(Rated Load)
≤1.8A
Operating
Temperature
-20℃~50℃
Hammer
Cross screw
driver
PencilElectric drill
10MM
Spanner
14MM
3. Installation Instruction
Item
Model
Product
Dimension
TV Size
Max
Installation
Min
Installation
Net WeightLoading
L/R
Angle
Up
Angle
Down
Angle
(mm) (mm)
(mm)
(°) (°) (°)
(kg)(kg)
(inch)
42
690*390*1070
600*400 200*200
60 ±15
±
10
5
ZX-C23AG
Return:Press the key the mount will come back to the original positon.
Stop: Press the key the mount will stop in the course of return.
4-2.2 Operating Instruction
A. Insert one 23A 12V battery in the , the effective distance is
within 10 meters.
When user presses any function key (up, down, left, right,raise and lower)
of Remote control,the TV bracket with TV will move to the corresponding
direction, and will stop when you loosen the key.
Remote control
B.
If any remote of our product was lost or damaged, you can
buy a new remote control with the same frequencies which produce
by our company and do following operation:
control
Changes or modifications not expressly approved by the party resp-
onsible for compliance could void the user's authority to operate the
equipment.
B.
A. Memory cleaning: Press coding key about 10 seconds, the memory
will clean after the LED indicator closed. (The memory is the coding
memory of the previous remote control).
Use new remote control: Press any key of remote control and the
coding key1-2seconds at the same time, Loosen remote control firstly,
Then loosen the coding key, Finally, you can operate the product with
new remote control.(Coding key ,Indicator, Please see diagram7).
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against ha-
rmful interference in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful inte-
rference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined b turning the interference by one or more of the fo-
llowing measures:
--Reorient or relocate the receiving antenna.
--increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
4-2.3 Notice
Warning: