User's Manual

3.Installation Instruction
3-1 .Installation method:
1.Make the mark at the place of ceiling that you want to mount
the TV.Use percussion borer to drill 8 holes on the mark,at
Φ10mm and 70 depth .Take out 8 pcs 6 expansion screws
from the fitting bag,insert them throngh the holes of cart into
the hole of ceiling by hammer and fasten them by wrench.( see
the diagram) Note:After fasten the cart,connect power,press”
lower”key on the remote sensor to extend the cart and take
away silicon rubber cushion.Do not press”raise” key before
take away the silicon rubber, or the inside parts will be
damaged.
After fast en the car t,
pleas e take away
the rubbe r cus hi on .
Correct installation is extremely essential and falls outside the
scope of responsibility of manufacturer,Theuser must pay
attention to the weight of TV and TV mount,and only solid wall
can support the weight.Please complied with the installation
instruction of LCD/PDP to install them.
Correct installation is extremely essential and falls outside the
scope of responsibility of manufacturer,Theuser must pay
attention to the weight of TV and TV mount,and only solid wall
can support the weight.Please complied with the installation
instruction of LCD/PDP to install them.
3-4.NOTICE:
Do not connect
before fasten the
product.
Make sure wire and
plug are good before
connecting.
X
X
2-2.Motor
2.Electric Specification
III.Caution:
3-3.Technical Paramters:
Warning:This ceiling mount’s load-bearing weight must be
at the range of the indicated max load-bearing weight,Use
with heavier than the maximum weights indicated may
result in instability causing possible injury!
Warning:This ceiling mount’s load-bearing weight must be
at the range of the indicated max load-bearing weight,Use
with heavier than the maximum weights indicated may
result in instability causing possible injury!
If any remote control of our product was lost or damaged ,
you canbuy a new remote control with the same frequency
which produce by our company and do following operation:
1. Memory cleaning: press coding key about 10 seconds ,the
memory will cleaned after the indicator closed.(The memor
is the coding memory of the previous remote control).
2. Use new remote control:press any key of remote control
and the coding key1-2seconds at the same time ,loosen
remote control firstly ,then loosen the coding key ,finally ,
you can operate the product with new remote control .
(Coding key , Indicator,please see diagram).
Item
Rated
Voltage
Current
(No load)
Current
(Rated load)
Operation
temperature
DN3435-3825E
DC24V
≦0.7A
≦1.8A
-20℃~50℃
DN3435-3046E
DC24V
≦0.5A
≦1.5A
-20℃~50℃
Motor
PR545AG-16190-RB35C-1000
DC24V
≦0.3A ≦0.5A -20℃~50℃
mm
mm
Φ
Notice: Screw the
nut into the expansion
bushing about 1mm
before fix it to the wall
(see below diagram)
6
40
2-1.Input Voltage/Current/Frequency:
100-240VAC,< 1.2A,50/60Hz
Output Current: DC24V ,3A