User's Manual

5.Adjust the elevating stand to the bottom position, turn off the switch,
fix the TV rail to elevating stand by M6X10mm screws. (See diagram 5)
8
Diagram 5
M6*10mm
TV rail
6.Screw up tabs on the upper holes of TV back cover by sink head
screws,then , hook TV brackets on the tabs . Fasten lower end to TV
back cover by screwing up round head screws, washers and pads.
(See diagram 6)
2
1
Di agram 6
TV bracket
7
3
4
4.Connect the power supply and turn on the switch,use remote control or
manual control to rise the elevating stand to the top position, then fix
the wall mounting rack to the wall by expansion screws, and connect
the base plate and elevating stand by M6X10mm screws.(see diagram 4)
9
3.Fasten base plate on the ground by M6X50mm self- tapping screws.
(See diagram 3)
6
8
Coding key
Codi ng key
LED Indicator
RAIS E
LOWE R
M6*10mm
Diagram 4
Diagram 3
開
關
switch
Warning:
After TV has
mounted ,
turn the key
to right to un-
lock the slider
of elevating
stand before
connect the
power. If ne-
ed to move
this product to
another place ,
must down the slider to
bottom and turn the
key to left to lock the
slider before make any
movement.
!
Expansion screw
mm
MM
Φ
Notice: Screw the
nut into the expansion
bushing about 1mm
before fix it to
the wall
(see below
diagram)
9