User's Manual
1-3.Assembly Tool(Not included):
Cross
screwdriver
Hammer
Spanner
14mm
Pencil
Electric drill
10mm
Check all the parts as shown on the manual
included .If parts are missed or damaged,do not
use it and please return to your local distributor.
Check all the parts as shown on the manual
included .If parts are missed or damaged,do not
use it and please return to your local distributor.
Warning:
:
Warning
!
Notice:Notice:
2.Electric Specification
2-1.Input Voltage/Current/Frequency:
100-240VAC/< 1.2A/50~60Hz
Output Current: DC24V ,3A
2-2.Motor
Correct installation is extremely essential, and falls
outside the scope of responsibility of manufacturer .
The user must pay attention to the weight of TV and This
product, and only solid wall can support the weight .
Please complied with the installation instruction of
LCD/PDP to install them.
Correct installation is extremely essential, and falls
outside the scope of responsibility of manufacturer .
The user must pay attention to the weight of TV and This
product, and only solid wall can support the weight .
Please complied with the installation instruction of
LCD/PDP to install them.
B.Remote control
(See diagram 9) :
Ⅰ.Key Function
1.V.P.:one push to
extend elevating
stand to the top.
H.P.: one push to
back elevating
stand to the bottom.
2.Raise:hold on to
raise elevating
stand. Lower: hold
on to lower elevating
stand.
Diagram 9
Horizontal
Position
Lower
elevating
stand
LED Indicator
R
IS
E
A
L
WO E
R
V
.P
.
H
.P.
Vertical
Position
Raise
elevating
stand
Ⅱ.Operating
Instruction
1.Aim the LED indic-
ator (on remote cont-
rol )at TV . The remote
range is 3 - 10m.
2.Insert one 23A,
12V battery in the
remote control. If
the battery ran out ,
please open the battery cover and put in new battery.
3.When user press any function key of remote control, the TV
bracket with TV will move to the corresponding place ,and will
stop when you loosen the key.
Ⅲ.Notice
If any remote control of our product was lost or damaged ,you
can buy a new remote control with the same frequency which
produce by our company and do following operation:
1.Memory cleaning: press coding key about 10 seconds ,the
memory will cleaned after the indicator closed.(The memory is the
coding memory of the previous remote control).
2.Use new remote control: press any key of remote control and the
coding key1-2seconds at the same time ,loosen remote control firstly,
then loosen the coding key ,finally ,you can operate the product with new
remote control .(Coding key ,Indicator,please see dingram 4).
3-3.Technical Parameters:
640
50
7
8
Loading