Data Sheet

www.switches-sensors.zf.com

Page 2 of 2, Last update 2016-07-06, Specifications subject to change without notice.

Note: An external pull-up resistor is required, the value of which is dependent on the supply voltage. The resistor should be

connected between the output and Vcc. Refer to the wiring diagram for lead colors or pin numbering as applicable.

Recommended External Pull-Up Resistor

Volts DC

Ohms

1.8k

2.4k

Open Collector Sinking Block Diagram

Dimensions mm (inches)

GS100701 GS100501

Installation

For best results, we recommend targets made from low carbon cold rolled

steel. Other factors that influence sensor performance include gear tooth

height and width, space between the teeth, shape of the teeth and thickness

of the target. As a general guideline, consider a target with minimum

parameters as shown below. Note that smaller dimensions may work, but

testing for the application is required.

Tooth Height

Tooth Width

Distance between

Teeth

Target Thickness

5.0 mm (.200")

2.5 mm (.100")

10 mm (.400")

6.35 mm (.250")

GS100502