Instructions / Assembly

www.ihomeangel.com
Page:  3  / 3
[phone] Working hours : Mon  Fri 9:00 a.m.  16:00 p.m. EST
[e-mail]
Connect ground wires according to the below chart Connect wires according to the below chart
Twist wires together with plastic wire connectors until tightly joined, and
wrap each connector with approved electrical tape. Be sure that no wire
strands are exposed and then carefully tuck all wires into the outlet box.
Step A4: Align the holes in back plate (E) with the preassembled mounting screws, then attach back
plate (E) to mounting plate (D) with the previously removed knob nuts (F). Hand tighten until
snug.
NOTE: back plate (E) should be snug against the wall with knob nuts (F).
If not, remove back plate (E), adjust the threaded length of preassembled
mounting screws on mounting plate assembly (D) by unscrewing the pre
assembled hex nuts and then screwing the preassembled mounting
screws in or out of mounting plate (D) until the secure length is achieved.
Tighten the preassembled hex nuts and back to Step A4.
Step A5: 1) Install the bulb (Not included) (Please do not exceed the maximum wattage recommended
on the socket.)
2) Carefully slide two iron wires of cloth lampshade (G) along the bulb, so cloth lampshade (G)
holds the bulb properly by iron wires.
4. Check everything is installed properly, then you could turn on the light. Enjoy!
Step A1: Unscrew knob nuts (F) from back plate (E), then set them aside for later installation.
Step A2: Carefully pass the supply wires from the outlet box through mounting plate (D).
Secure mounting plate (D) to the outlet box with mounting screws (A).
Step A3: Make wire connections
Connect wires as below wires connection shown. PLEASE NOTE THAT GROUND WIRE IS
BARE COPPER WIRE, NEVER CONNECT OTHER WIRES TO GROUND WIRES.
ORDERING PARTS
Keep this sheet for future reference in case you
need to order replacement parts. All parts for this
fixture can be ordered from the place of purchase.
Be sure to use exact wording from illustration when
ordering parts.
CLEANING
To clean, wipe the fixture with a soft cloth. Do not
use abrasive materials such as scouring pads or
powders, steel wool or abrasive paper.
[e-mail]