Specifications

303
TNPP and System Startup Events Reporting
Would correspond to the following events table:
In addition to the above entries, the time of the last occurrence is kept in the event table.
The last occurrence information will be displayed if the event happened since the last
reboot or if the -d switch is used.
NETWORK.CUS
The network.cus command line that controls events reporting is formatted as follows:
PORTS <port-selection> REPORT <events-selection>
PORTS is the command keyword that tells the system to report events on the specified
port(s).
The field <port-selection> identifies which port(s) should report the specified events.
Table 50 shows what types of entries are valid.
REPORT is a command keyword that tells the system to report upon the specified
event(s).
Table 45: Valid Entries for the <port selection> Field
The field <events-selection> identifies which TNPP events to report. Table 46 shows the
currently supported events and the command line keywords to identify them.
Action
Event Type
Page FaultRelay
StartUp 123-4567 “System Startup”
TNPP 123-4567 “**TNPP problem**” ON
<port selection>
Text
Ports to Monitor (1 through 8)
* all TNPP serial ports
ALL all TNPP serial ports
1 a specific port number (port 1 in this case)
245 all ports listed (ports 2, 4, and 5 in this case)