Specifications

Configuring Station Transponder Units
66 025-9581M
parameter accepts any value between 0.00 and 59.99 seconds. Typically it is set for about
0.25 seconds.
Trunking Grant Debounce
This parameter is no longer used.
Trunking Grant Timeout
This parameter is no longer used.
Trunking Grant Retry Delay
This parameter is no longer used.
TX Delay
This parameter is found in the Station Configuration Menu. It sets the delay time that the
Model 6203 waits, after receiving a valid FFSK packet, before asserting PTT for a
response in the Trunking Modes. This parameter accepts any value between 0.00 and
59.99 seconds. The value defaults to 0, but should be increased in situations where the
sending radio, which sent the stimulus (poll), needs more time to turn around to receive
after transmission.
“Communications Mode” Menu
Figure 14: The Communications Mode Menu
Note The firmware in the Model 6203 is based on an earlier product that
also supported wireline connections. Please ignore any references
to wireline that appear in the menus. This mode is no longer
supported.