Specifications

Configuring Station Transponder Units
64 025-9581M
Figure 13: The COR Mode
All of the programmable parameters are described in the following paragraphs.
Station or 4 Unit Display
This is the first parameter listed in the Station Configuration Menu. It determines whether
the first column of LEDs on the Model 6203 front panel represents the station status or a
unit (vehicle) status. If the Model 6203 is the primary unit, this parameter is normally set
for Station status displayed. If the Model 6203 is a secondary unit (address greater than
512) then this parameter is normally set to 4 Unit Display.
Unit Enables
This is the second parameter listed in the Station Configuration Menu. This parameter is
used to select which units (vehicles) are active on the Model 6203. Selecting this
parameter displays another menu where individual units can be enabled or disabled. If a
unit is disabled its status will no longer be displayed and its alerts will no longer be
sounded.
Always Sound Unit Alerts
This is the third parameter listed on the Station Configuration Menu. This parameter deals
with how alerts are sounded for units (vehicles) which are not In Quarters. Selecting this
parameter from the menu toggles between always sounding unit alerts or only sounding
unit alerts when the unit’s status is In Quarters.
Communications Mode
This is the fourth parameter listed in the Station Configuration Menu. This parameter
holds the Communication Mode that the Model 6203 is currently operating under and this
in turn effects the parameters that are displayed in the Station Configuration Menu. When