Specifications

55
CAD Translator
Viewer Configuration
To open the communications viewer configuration window, start the FSA Serial CAD
Viewer program and then click on the Config
label found just under the title bar on the
right.
The settings in this dialog box configure the viewer to get information from the translator.
Host
This parameter is the IP address of the computer that is running the CAD
Translator.
Port
This parameter is the port being used by the CAD Translator program. It defaults to
43003 and should not be changed.
Using the Communications Viewer
When the FSA Serial CAD Viewer is started, it opens the window shown here. Once the
configuration information has been entered it will automatically start to populate its two
panes with information about the messages passing back and forth between FSA Server
and the CAD system.