Specifications
51
Installing the UBAM™ Components
UBAM Repeater
There are no special requirements for the machine running the UBAM Repeater utility.
The machine does not have to be connected to the network in order to perform the UBAM
Repeater utility installation.
There are no problems associated with running both the UBAM Listener and the UBAM
Repeater on the same machine.
♦ UBAM Repeater Installation
1. Insert the IP FSA Suite CD in the computer’s CD or DVD drive. The installation
routine should start automatically and display the opening screen. (If it does not,
use the RUN command on the Start menu to browse the CD-ROM root directory,
select the Autorun.exe file, and run it.)
2. From the opening screen, select the FSA VoIP Installation menu, select the
UBAM Repeater option, and click the Install 'UBAM Repeater' button. The
installer for the UBAM utility will start.
3. Follow the on-screen instructions of the installer. At some point the installer will
prompt for the IP address and port number of the instance of UBAM Listener to
which the repeater connects.
4. The installer will provide a list of port numbers that must be open to allow traffic
to pass between network segments for the UBAM utilities. Copy these down so
you can make firewall exceptions later if necessary.
5. When the installation is complete, you may remove the CD-ROM from the drive.
6. If there is a firewall running on any of the computers involved, set up exceptions
for the port numbers you recorded in step 4.
Note Before installing any of the UBAM Utilities software, ensure that
Windows is properly configured. See Preparing the Console
Computer
on page 37.
Note Always use the default port assignment for any VoIP configuration.
Note Once installed, the UBAM Repeater utility runs in the background
as a Windows service.