Specifications

Overview
107
Installing the Station Transponder
Units on Site
Overview
This section covers the mounting, basic connections to, and configuration of the Station
Transponder Units. Because the Model 6203 and Model 6204 are very similar in
construction and internal layout, only the Model 6203 will be described here. If anything
that is specific to the Model 6204 needs to be described, it will be identified as such.
The configuration of software settings for the Station Transponder Units is described in
Configuring Station Transponder Units on page 57 or Basic System Configuration on the
Bench on page 79.
For descriptions of the various connectors, jumpers, switches, and potentiometers in the
Station Transponder Unit, see Appendix A: Details of Model 6203/6204 Hardware on
page 147.
Equipment Needed
The installation of the Station Transponder Units in the field will require the use of some
or all of the following resources.
• Typical set of hand tools for an electrician/electronics technician
• A multimeter for measuring voltages
Note When communicating with the Model 6203 units by means of the
network connection, the port 2101 is always open.